Torbjörn Thiringer
According to our database1,
Torbjörn Thiringer
authored at least 19 papers
between 2009 and 2021.
Collaborative distances:
Collaborative distances:
Timeline
Legend:
Book In proceedings Article PhD thesis OtherLinks
On csauthors.net:
Bibliography
2021
Design and Verification of In-Slot Oil-Cooled Tooth Coil Winding PM Machine for Traction Application.
IEEE Trans. Ind. Electron., 2021
2020
Assessment of an Improved Finite Control Set Model Predictive Current Controller for Automotive Propulsion Applications.
IEEE Trans. Ind. Electron., 2020
Proceedings of the 46th Annual Conference of the IEEE Industrial Electronics Society, 2020
Sensorless Capacitor Voltage Balancing of a Grid-Tied, Single-Phase Hybrid Multilevel Converter with Asymmetric Capacitor Voltages using Dynamic Programming.
Proceedings of the 46th Annual Conference of the IEEE Industrial Electronics Society, 2020
Online and On-Board Battery Impedance Estimation of Battery Cells, Modules or Packs in a Reconfigurable Battery System or Multilevel Inverter.
Proceedings of the 46th Annual Conference of the IEEE Industrial Electronics Society, 2020
Power Loss Analysis in a SiC/IGBT Propulsion Inverter Including Blanking Time, MOSFET's Reverse Conduction and the Effect of Thermal Feedback Using a PMSM Model.
Proceedings of the 46th Annual Conference of the IEEE Industrial Electronics Society, 2020
Proceedings of the Fifteenth International Conference on Ecological Vehicles and Renewable Energies, 2020
2019
On V<sub>c</sub> Method: In Situ Temperature Estimation and Aging Detection of High-Current IGBT Modules Used in Magnet Power Supplies for Particle Accelerators.
IEEE Trans. Ind. Electron., 2019
Heat transfer coefficients in a coupled 3-D model of a liquid-cooled IPM traction motor compared with measurements.
Proceedings of the Fourteenth International Conference on Ecological Vehicles and Renewable Energies, 2019
Demagnetisation current due to short circuit effect on an inset permanent magnet motor.
Proceedings of the Fourteenth International Conference on Ecological Vehicles and Renewable Energies, 2019
2018
Three traction motors with different magnet materials - Influence on cost, losses, vehicle performance, energy use and environmental impact.
Proceedings of the Thirteenth International Conference on Ecological Vehicles and Renewable Energies, 2018
Proceedings of the Thirteenth International Conference on Ecological Vehicles and Renewable Energies, 2018
2016
Characterizing BEV Powertrain Energy Consumption, Efficiency, and Range During Official and Drive Cycles From Gothenburg, Sweden.
IEEE Trans. Veh. Technol., 2016
Improvement of admittance measurements for modeling of an ungrounded reactor/transformer winding.
Int. J. Model. Simul. Sci. Comput., 2016
2014
Proceedings of the IECON 2014 - 40th Annual Conference of the IEEE Industrial Electronics Society, Dallas, TX, USA, October 29, 2014
2013
Analysis of power losses and efficiency up to 60 kW DC-DC converter for hybrid electric vehicle with different inductive core materials.
Proceedings of the 22nd IEEE International Symposium on Industrial Electronics, 2013
2012
Performance and loss evaluation of a hard and soft switched 2.4 MW, 4 kV to 6 kV isolated DC-DC converter for a wind energy application.
Proceedings of the 38th Annual Conference on IEEE Industrial Electronics Society, 2012
Evaluation and comparison of a two-level and a multilevel inverter for an EV using a modulized battery topology.
Proceedings of the 38th Annual Conference on IEEE Industrial Electronics Society, 2012
2009
IEEE Trans. Educ., 2009