According to our database1, Hyungjun Park authored at least 21 papers between 1995 and 2015.
Legend:Book In proceedings Article PhD thesis Other
Adaptive B-spline volume representation of measured BRDF data for photorealistic rendering.
J. Computational Design and Engineering, 2015
Tangible AR interaction based on fingertip touch using small-sized nonsquare markers.
J. Computational Design and Engineering, 2014
Connected Vehicle Enabled Freeway Merge Assistance system-field test: Preliminary results of driver compliance to advisory.
Proceedings of the 2014 IEEE Intelligent Vehicles Symposium Proceedings, 2014
Design evaluation of information appliances using augmented reality-based tangible interaction.
Computers in Industry, 2013
B-spline surface fitting based on adaptive knot placement using dominant columns.
Computer-Aided Design, 2011
Immersive modeling system (IMMS) for personal electronic products using a multi-modal interface.
Computer-Aided Design, 2010
Tangible augmented prototyping of digital handheld products.
Computers in Industry, 2009
Reducing control points in lofted B-spline surface interpolation using common knot vector determination.
Computer-Aided Design, 2008
B-spline curve fitting based on adaptive curve refinement using dominant points.
Computer-Aided Design, 2007
A note on morphological development and transformation of Bézier curves based on ribs and fans.
Proceedings of the 2007 ACM Symposium on Solid and Physical Modeling, 2007
Geometric Properties of Ribs and Fans of a Bézier Curve.
J. Comput. Sci. Technol., 2006
B-Spline Curve Fitting Using Dominant Points.
Proceedings of the Computational Science, 2006
Error-Bounded B-Spline Curve Approximation Based on Dominant Point Selection.
Proceedings of the 2005 International Conference on Computer Graphics, 2005
An error-bounded approximate method for representing planar curves in B-splines.
Computer Aided Geometric Design, 2004
Error-bounded biarc approximation of planar curves.
Computer-Aided Design, 2004
Co-Validation Environment for Memory Card.
Proceedings of the 15th IEEE International Workshop on Rapid System Prototyping (RSP 2004), 2004
Lofted B-spline surface interpolation by linearly constrained energy minimization.
Computer-Aided Design, 2003
Choosing nodes and knots in closed B-spline curve interpolation to point data.
Computer-Aided Design, 2001
A method for approximate NURBS curve compatibility based on multiple curve refitting.
Computer-Aided Design, 2000
Smooth surface approximation to serial cross-sections.
Computer-Aided Design, 1996
An adaptive method for smooth surface approximation to scattered 3D points.
Computer-Aided Design, 1995